LT3475/LT3475-1
APPLICATIONS INFORMATION
Open Circuit Protection
The LT3475 has internal open-circuit protection. If the LED
OUT
10k
is absent or is open circuit, the LT3475 clamps the voltage
on the LED pin at 14V. The switching regulator then oper-
ates at a very low frequency to limit the input current. The
LT3475-1 has no internal open circuit protection. With the
LT3475-1, be careful not to violate the ABSMAX voltage of
22V
100k
V C
th BOOST pin; if V IN > 25V, external open circuit protection
circuitry (as shown in Figure 1) may be necessary.The
output voltage during an open LED condition is shown in
the Typical Performance Characteristics section.
3475 F01
Figure 1. External Overvoltage Protection
Circuitry for the LT3475-1
LT3475
V IN
V IN
Undervoltage Lockout
Undervoltage lockout (UVLO) is typically used in situations
R1
SHDN
2.6V
V C
where the input supply is current limited, or has high source
resistance. A switching regulator draws constant power
C1
R2
9μA
GND
3475 F02
from the source, so the source current increases as the
source voltage drops. This looks like a negative resistance
load to the source and can cause the source to current limit
or latch low under low source voltage conditions. UVLO
prevents the regulator from operating at source voltages
where these problems might occur.
An internal comparator will force the part into shut-
down when V IN falls below 3.7V. If an adjustable UVLO
threshold is required, the SHDN pin can be used. The
threshold voltage of the SHDN pin comparator is 2.6V. An
internal resistor pulls 9μA to ground from the SHDN pin
at the UVLO threshold.
Choose resistors according to the following formula:
Figure 2. Undervoltage Lockout
Keep the connections from the resistors to the SHDN pin
short and make sure the coupling to the SW and BOOST
pins is minimized. If high resistance values are used, the
SHDN pin should be bypassed with a 1nF capacitor to
prevent coupling problems from switching nodes.
Setting the Switching Frequency
The LT3475 uses a constant frequency architecture that
can be programmed over a 200kHz to 2MHz range with a
single external timing resistor from the R T pin to ground.
R2 =
2.6V
V TH – 2.6V
R1
– 9 μ A
A graph for selecting the value of R T for a given operating
frequency is shown in the Typical Applications section.
Table 1. Switching Frequencies
SWITCHING FREQUENCY (MHz)
R T (kΩ)
V TH = UVLO Threshold
Example: Switching should not start until the input is
above 8V.
V TH = 8V
R1=100k
2
1.5
1.2
1
0.8
0.6
4.32
6.81
9.09
11.8
16.9
24.3
R2 =
2.6V
8V – 2.6V
100k
– 9 μ A
= 57.6k
0.4
0.3
0.2
40.2
57.6
100
3475fb
8
相关PDF资料
LT3476EUHF#PBF IC LED DRVR HP CONST CURR 38-QFN
LT3477EFE#PBF IC LED DRVR HP CONS CURR 20TSSOP
LT3478IFE#PBF IC LED DRVR HP CONS CURR 16TSSOP
LT3486EFE#PBF IC LED DRVR WHITE BCKLGT 16TSSOP
LT3491EDC#TRMPBF IC LED DRIVER WHITE BCKLGT 6-DFN
LT3492IFE#TRPBF IC LED DVR HP CONST CURR 28TSSOP
LT3496IUFD#PBF IC LED DRVR WHT/RGB BCKLT 28-QFN
LT3497EDDB#TRMPBF IC LED DRIVR WHITE BCKLGT 10-DFN
相关代理商/技术参数
LT3475EFE-1#PBF 制造商:Linear Technology 功能描述:LED DRIVER BUCK PWM 600KHZ 制造商:Linear Technology 功能描述:LED DRIVER, BUCK, PWM, 600KHZ, TSSOP-20
LT3475EFE-1#TRPBF 功能描述:IC LED DRVR HP CONS CURR 20TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - LED 驱动器 系列:- 标准包装:6,000 系列:- 恒定电流:- 恒定电压:- 拓扑:开路漏极,PWM 输出数:4 内部驱动器:是 类型 - 主要:LED 闪烁器 类型 - 次要:- 频率:400kHz 电源电压:2.3 V ~ 5.5 V 输出电压:- 安装类型:表面贴装 封装/外壳:8-VFDFN 裸露焊盘 供应商设备封装:8-HVSON 包装:带卷 (TR) 工作温度:-40°C ~ 85°C 其它名称:935286881118PCA9553TK/02-TPCA9553TK/02-T-ND
LT3475EFE-1-PBF 制造商:LINER 制造商全称:Linear Technology 功能描述:Dual Step-Down l 1.5A LED Driver
LT3475EFE-1-TRPBF 制造商:LINER 制造商全称:Linear Technology 功能描述:Dual Step-Down l 1.5A LED Driver
LT3475EFEPBF 制造商:Linear Technology 功能描述:Dual Step-Down 1.5A LED Driver,LT3475
LT3475EFE-PBF 制造商:LINER 制造商全称:Linear Technology 功能描述:Dual Step-Down l 1.5A LED Driver
LT3475EFE-TRPBF 制造商:LINER 制造商全称:Linear Technology 功能描述:Dual Step-Down l 1.5A LED Driver
LT3475FE-1 制造商:LINER 制造商全称:Linear Technology 功能描述:Dual Step-Down l 1.5A LED Driver